If you have a 3d printer, i recommend this for Digis
https://www.printables.com/model/113415-elektron-digitakt-stand/comments
I am using 2 laptop stands from IKEA. The large models (not the small ones). Can’t remember the name but it is pretty handy.
Have put some rubber pads under to avoid it slipping away 
Both are connected with 2 aluminium plates and 2 sets of screws each.
Works perfectly.
1 Like
I am also using three cheap laptop stands by Nevoya you can buy on Amazon etc.:
Curious why people put DT right and DN left, I have it the other way round as I fiddle more with DN and am right-handed
1 Like
Nice setup. How do you incorporate the Mic into this setup? Via DT into OT?
I much prefer to have the OT flat; and the DT and DN above it at an angle… or the other way around.
Can’t find a decent stand yet so have them all lined up for now.
My idea was to get a case, either a square one or a long one and then take the lid off and put it on a desk at an angle.
1 Like
The mic goes straight into my interface, where I have it on an Ableton track with compressor and reverb. I’ve tried to make it work with a preamp, OT and effects pedals for quite some time, but there was just too much boxes for a disappointing sound.
Recently ried to do some live vocal looping/manipulation with Roland E4 and OT in a live setting, but didn’t really come up with anything interesting and also had problems with gain staging.
You could try cheap 3D-printed angles like I use for my Rev2 at the bottom on the picture posted for your OT.
1 Like
anybody know what stand he’s using for the octatrack?
3 Likes