Just to tilt it up to face you?
Sure, dremel and some duct tape will sort that right out.
3 Likes
This sounds like the sort of thing where if you have to ask, you shouldn’t be attempting it
3 Likes
If you have a 3d printer and some cad design skills anything is possible with a big enough budget.
See if you can find a service manual that shows an exploded view of the hardware schematic and that way you can figure out how it’s held in place without disassembling, that will make it easier to give a realistic estimate of difficulty.
I think it’s probably not a good idea though considering the cost of the device. Might be a better idea to build a large tilting seat/stand thing and be content with using it at an angle rather than flat with a tilt screen.
Just from the perspective of time and cost and headaches and tears and snack wrappers.
2 Likes
Or something like this! Wanted bad when I had a MPC!
3 Likes
Why not just stick it on a laptop stand? That’s what I do. Works great.
3 Likes
good Ideas and I have a quik-lok stand like that as well as some other desk top stands that give lift but I don’t like them… even on the mpc I don’t like how it feels.
I just want to raise the screen but leave the Push flat, an itch I cannot scratch perhaps
1 Like